Portraiture HELP.

Last week, I was asked to do a photoshoot for my friends. It was informed to me that the pictures I will shoot should be in a black and white photo and also using white wall.

Sunday afternoon inside the building, I took sample pics and there wasn't enough natural light to come in, so I brought 2 of my halogen lights (yellow). I was wondering on how to prevent the shadows from the wall and avoid blur. Should I use flash? smaller apertures? The flash I'm using is just the built in flash of my 400D. I have no external flash for my canon.

Here's a sample picture below. Comments, suggestions and ideas are very much appreciated. I'm a bit of hurry so I could get ready again this Saturday. Thanks in advance!

Tags: help, portrait

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Aaron on November 26, 2008 at 9:13am

TRIPOD to prevent blur.
You could use one of your halogens as a back light. Placed on the ground or hung from above (also a hair light) behind the subject to help eliminate shadows.
Use your built in flash set to TTL.
You can use your other halogen as a dramatic light or point it at the wall to any side to simulate a softer light source. Or point it through a sheet (soft box sort of).
The use of a tripod will allow you to shoot at a more appropriate speed to use what natural light you may have.

Hope these ideas help.
Good luck and show us the finished product.

Aaron

▶ Reply

Permalink Reply by Michael Bartholome on November 26, 2008 at 9:20am

Maybe you could move the people further away from the wall. I had the same problem when I used a mounted flash and turned the camera. If the flash was above the camera, not to the side, the shadow would be further down the wall and you may not be able to see it. Aso agree with Aaron.

▶ Reply

Permalink Reply by Mithindril on November 26, 2008 at 1:20pm

It's hard under those circumstances to reduce the shadows. Studio lighting, with a backlight will usually work, but if that's not in the budget... The blur is usually due to the speed of the shutter and or the aperture. I had a lot of blurring in the beginning and it was both.

You can reduce the effects of the shadows by using a wall with texture or plants.

Good luck

▶ Reply

Permalink Reply by Sean on November 27, 2008 at 8:59pm

Here you go, lighting on a budget...You can get work lights at your hardware store that can handle up to 300 watt bulbs, get two, they usually run about $15 a piece plus $4 for a 300 watt bulb. Put one light on each side of the model at about 45 degrees...so you will get very little if any shadows...if you have enough money get a third that is aimed at the wall from the floor behind the model. If you want more control over the light you can buy a cheap dimmer for one or two of the lights.
Do not use your flash...it will be too harsh for portraits.
Tripod is a must since you seem to have a motion blur issue. Or increase your shutter speed to 1/125 or faster.
This set up got me through until I could afford strobes.